New Firmware available for DJI Matrice 4 Series
- Thread starter jaja6009
- Start date
was this released or a couple of days ago? I started getting a geofence warning at my house. Aloft says it is limited to 100ft AGL.
You may be able to toggle those warnings off but all DJI drones are currently unlocked
The new firmware came out 8/28/25.
The AR Streets was running on mine after update.
Steve, the warning should not lock you out of flying as JaredRing stated.
DJI just warns you of controlled air space and other hazard areas, but should not lock you out from flying.
The AR Streets was running on mine after update.
Steve, the warning should not lock you out of flying as JaredRing stated.
DJI just warns you of controlled air space and other hazard areas, but should not lock you out from flying.
Thanks for the update info, but I did yesterday all updates and are different vesion
Aircraft shows 14.01.0012 ,remote controller 01.64.0523
should I check it again?
Aircraft shows 14.01.0012 ,remote controller 01.64.0523
should I check it again?
Last edited:
I would think the next time you log in with an internet connection you should get the update prompt. Mine showed a new firmware last night and I updated it.
Yes, I flow the M4T a couple hours ago connected to internet and shown new firmware available
I leave it for later at home to do but when already connected to internet in very shot of time everything was updated.
How is that possible without touching on screen to upgrade it
I leave it for later at home to do but when already connected to internet in very shot of time everything was updated.
How is that possible without touching on screen to upgrade it
