Recent content by timmydjr

I am using the P1 camera. Again, I think it is internal component problems. But hopefully I can get that tested in the next week. I will fly it and do a screen recording and then do the calibration and fly it again to see if it corrects it or if it is just a myth.

I have not yet had a chance to try the calibration and see if that fixes it. I own 2 of the M300's and both of them throw Avionics Overload/Errors during flight. I had to send one back because the props are on so tight that the bolt head broke off when trying to remove the props to swap them...

Keeg, you would use DJI Assistant for that. This might help.

I wanted to see if anyone could provide insight on the Avionics overload error message. I am running the P1 and I get the error message continually. Checking to see what is causing this and how to fix it.

I inserted a slightly longer M3 and it is holding tight. On a different note, I painted the top half of the m200 white to keep it cool. if I have further problems with the leg brackets, or heat issues, I am going to still have to go ahead and tear it down and see if there is a problem with the...

Thank you very much for the detailed info on how to break this down. so my problem is that I was walking out the door and one of my legs caught the side of the door and pulled the screw out of the bracket that's behind the shell. I do not know if it just stripped it out but I can't seem to get...

I know this is an old post, but did you ever figure out separating the top shell? I cannot find any information on the trick to get it separated. I'm actually going to paint the top shell white to keep it cool, but I also hit the leg on a doorway and it popped the screw out that holds the...

So would the DNG (20 fps burst) not work writing to SD card? I don't think you can save photos to the SSD. I don't have the SSD option so not 100% sure. But that is what I understood from the reading I did. The SSD is only for CinemaDNG and AppleProRes.

Thanks Nick! It is working today. Several things worth noting. 1. I am only using one controller (the Cendence). It was set to "Master" and I changed the selection to "OFF". I would assume that if it is not being used in a dual controller setup, then the OFF option should be selected...

You will see this one on the link FlyaDrone posted above. This one is a really good and simple explanation

So I go my Cendence controller and everything seems to work fine except on thing. After the landing gear is raised, the gimbal will not yaw using the front right wheel. If it is on the ground (running or not) the gimball will rotate using the wheel and I can use the back button (c4??) to bring...