Recent content by Ro3go

Great respect for jaja6009:cool: always contributing something positive to the forum. What I'm trying to test is the accuracy of MT4, more than anything else, for my purposes it's quite reliable, and of course, this will depend on several factors. I've been mapping large areas, taking 1,000 to...

Using QGIS and the PDOK layers, you can see the flight's accuracy, see atachment, The orthomosaic with 50% transpacency

I use RTMP with youtub.... but I miss the audio

Very interesting topic; I'm precisely trying to confirm the accuracy of the M4T by creating an orthomosaic. Apparently, it's very accurate when connected via RTK through NTRIP using a caster in the region. Coincidentally, I'm in the same region as Mflyer look at RMS error attachment. Finally...

The DJI Matrice 600 (M600) and M600 Pro primarily use the DJI GO app for flight control and settings. Compatible DJI Apps DJI GO: The primary app for the Matrice 600 series. It is used for manual flight, camera control, and adjusting aircraft settings like intelligent landing gear. DJI Pilot...

Yes, the RTH has to be set higher than the mission altitude. Now, I don't know if the error is because the RTH is not correctly set in the mission or if in the general settings it is not the same as in the mission.

In my case, the thermal sensor turns off automatically when it accidentally points at the sun. I'm not sure if the Sunburn Protection option is enabled; I need to check it.

You are welcome and wel explained above:cool:

There are two ways to see the routes , 1. in the library 2. in the camera view In first one is from the main menu where is the library ,to see the Report you need to click in the routes icon In the two next are from the camera view ,here need to click selected one to show the report option

Just go back to routes in RC 2 Plus ,select the desired one then in blue "view task quality report" The aircraft must be connected

Everything is up to date in the list beside Pilot 2 app I have the version 15,0.0.8

In the main menu of UAV Health Management System you should see "Payload I" in green showing the sd card storage, if not something wrong with the Sd card In the RC plus 2 in photo/setting appears resolution as wel ratio and format but I not sure if you can change it , in my case not because I...

Yes, I flow the M4T a couple hours ago connected to internet and shown new firmware available I leave it for later at home to do but when already connected to internet in very shot of time everything was updated. How is that possible without touching on screen to upgrade it

Thanks for the update info, but I did yesterday all updates and are different vesion Aircraft shows 14.01.0012 ,remote controller 01.64.0523 should I check it again?

Thank you for the update. The other day I was flying over a dune area, at about 50 meters altitude, when suddenly a helicopter approached at low altitude, but no warning appeared on the pilot 2 screen. No idea why not getting any messages