Recent content by rilot

Are you talking about the little jumps when panning? It looks to me like a frame-rate mis-match. Is your output a factor of your shutter speed (50fps, 25fps etc for a shutter speed of 1/50)? If you are recording at 24fps or 60fps with a 1/50 shutter then it could cause this.

How are you going to control the camera? You will need the complete CAN system from an Inspire to make it work I would think. Maybe an Osmo handle disassembled and attached to the T810 might work? Wifi range is only a couple of metres though.

The 14-42 does have a certain amount of barrel and pin distortion. You just need to correct it as part of your post processing workflow. It's not a great lens to be honest but it's very useful in the air to have the ability to zoom.

It doesn't touch anything that moves. Just the side near the lens.

You won't have an issue with the 14-42mm pancake. It's a tight fit and the zoom ring will touch against the gimbal but other than that, it works just fine. You will need the balancer ring though.

AR have an anti-reflective coating. PL are polarizing.

No issues at all. Buy X5, install mounting plate, attach X5, upgrade to Inspire Pro firmware, IMU calibration, fly.

There are no do-it-all settings. The X5 is a proper camera and so you need to understand photography and what all of the settings do in order for you to decide on what settings you need for a given shot. Read up on aperture, focal-length, ISO, hyperfocal distance, and shutter speed. There are...

You will need the X5 adaptor plate and the X5. Once you have these then just install the Inspire Pro firmware and you are good to go. You should buy the X5 rather than the X5R unless you need to shoot RAW video and have the equipment and workflow to deal with it. I'm assuming that because you...

I know exactly where that is ;) Not far from there myself.

£81!!!! they're taking the piss.......

Thanks for posting this. Lets hope we can keep it updated.

Re-calibrate your lens then use manual focus set to the hyperfocal distance. Job done.

You can add the X5 to any Inspire. I have an X5 on my very early Inspire A and it's fine. You cannot buy the Inspire Pro without lens but there is no reason why you shouldn't just buy the X5 camera body, the adaptor plate and then just upgrade your Inspire. Bare in mind that you will need a new...

How do we go about calibrating this lens? I mean, if we calibrate for the hyperfocal distance at 42mm it's going to require a different calibration at 14mm. Or am I over thinking this?