Recent content by Mohan

You might be able to connect one camera using the AV input and the other camera using an HDMI input (if the camera has a HDMI output). That way you should be able to swith between AVI and HDMI on DJI Go although I haven't figured that one out yet as I have not plugged a HDMI camera into the N1...

You need to buy the DJI N1 video encoder which is a tiny flat box You take off the x3 gimbal holder and plate and use the 2 leads to connect to the N1 video encoder box You will receive 2 small cables - 1 lead is Gnd and positive video (yellow ) The other reserved lead has many wires but has...

It was always m1 prop that dropped and caused the wobble. Swapped M1 and M3 arms around and still had the problem. I found it cumbersome to swap the ESC around so I bought a spare set and replaced esc1 and it cured the problem. Subsequent flights I noticed a slight wobble and was getting...

You will be over the payload. I got around this by getting rid of the x3 gimbal camera and plate and using a small 10g camera and N1 video encoder which added 60g instead of 400g

I did sort my issue and is now flying perfectly. It was a faulty ESC on M1. Once replaced it was perfect. On subsequent flights I have come to appreciate that the alignment of the arms need to be 100% accurate. There is a notch that needs to lie in the groove perfectly Please check the arms...

I am not a photographer - I have a different requirement. Having had the AC in the air for 24 mins and flown 5 miles away and back I think it should cover most forward pushes if you need to get closer to the shot. As I said I am no photographer but for zoom you need magnification right? So if...

Chassis build v2 - doesnt appear to foul the cooling fan. In fact there is no protrusion from the cooling fan on the top plate I can't remember but I am sure when I first assembled the aircraft I had both battery bays at the same level. It must have caused vibrations as otherwise I would not...

Kris When you moved the battery backwards you are talking about moving towards the tail. So the top battery is moved further behind than the lower battery. This will make the CG even more rear centric. Already the craft tips backwards when you lift at its CG

M100 Wobble Dual Battery setup, X3 Gimbal - No guidance. AW under 3.4kg

Kris You moved both battery compartments to the rear? I lifted the craft at it's CG point and it is really heavy at the back. I then moved the top battery compartment forward it made it better although to balance it needed about 100g weight at the front. There is M100 specific firmware on the...

I have been flying the M100 for the past 48 hours using a dual battery setup 5700ma I get a very noticeable wobble every 2-3 minutes lasting 2-3 seconds when doing a hover test. It is very unsettling to see the aircraft wobble / almost judder. This worsens during the last 3-4 minutes as the...

Cardiff Wales - Love RC

DJI Inspire 1 dual controller