Recent content by Mistermf
-
M
Replacing X5 Gimbal Ribbon Cable
Wauw, good job! I broke that top of the shaft.- Mistermf
- Post #8
- Forum: Zenmuse X5
-
M
Replacing X5 Gimbal Ribbon Cable
Hey webeflyin, Nope, it went terrible. The thread that holds the main motor and is connected to the main axle, broke off. It is now beyond unrepairable. I have to send it in. The cable was within this last and main motor impossible to replace yourself. From now on I do advice to NOT repair it...- Mistermf
- Post #6
- Forum: Zenmuse X5
-
M
Help!
What happened is that you had a software version difference, between the drone and the remote. What you did was downgrade the remote software to re connect. 1.5.8 mostly gets you out of trouble. ALWAYS when you upgrade your software. Upgrade the drone first! Glad it worked out well. Cheers...- Mistermf
- Post #4
- Forum: Zenmuse X5R
-
M
Yes that's what I found out. Just read this a few moment ago. It explains a lot. It's halfway...
Yes that's what I found out. Just read this a few moment ago. It explains a lot. It's halfway the thread, explained by a moderator. http://www.inspirepilots.com/threads/terrible-horizon-drift-even-with-balanced-camera-and-lens-and-starting-up-on-flat-ground.13349/- Mistermf
- Profile post comment
-
M
Replacing X5 Gimbal Ribbon Cable
Hi, I am going to do that. Just ordered the parts today. (New yaw and roll arm + the ribbon cable) A mechanic from a premium dji dealer told me it was impossible to on your own, because there are chips inside that regulate the stability of the camera, and they have to be recalibrated by dji. I'm...- Mistermf
- Post #4
- Forum: Zenmuse X5