Recent content by Gregg Smith

Update, I did a job yesterday and had no issues with the I2 running latest firmware. Didn't even get the landing gear message at all. Horizon was rock solid. I ran through 7 sets of batteries and all was fine.

Good afternoon Jim, My video seems to be working ok now. I'm still getting the Landing gear alerts though. I've determined that this only happens if I'm in Sport or ATTI mode. If I'm in GPS mode it works fine. No alerts. And in Sport or ATTI mode, it's when I'm doing fast turns or it seems...

Update: I completed the Restore Factory Defaults, then upgraded to the latest firmware. Did a test flight. Same issue with landing gear. Video was ok though. So I took back in and did another Restore Factory Defaults to the upgraded firmware and re-flew the I2. This time I had good signal...

Thanks Michael. I didn't Restore Factory Defaults on it. I have updated the Cendence RC to the latest firmware. I've seen on another Inspire 2 thread that there seems to be an issue with the latest firmware. Have you updated to the newest firmware? If so are your I2's working ok? I'll try...

So after updating to July 2018 firmware V01.02.0200 I my horizon issue seems to be ok but signal was very broken and I kept getting voice alerts that landing gear lowering, landing gear raising without me touching anything. And now I remember, I had this same issue back in July when I tried...

Well I updated to latest firmware and did a couple IMU calibrations and a couple Auto Gimbal calibrations and that seems to have helped. Will be test flying later today to confirm.

Anyone else experiencing Horizon Tilt Issues with the April Firmware - V01.02.0100? I flew a couple weeks ago with the same firmware and had no issues. Yesterday I was doing a shoot and the camera would tilt like crazy. To the point where I had to input roll adjustments of 4-6 to make it...

Thanks for the update.

How have you like the conversion? Was it just a new lens for the X5S or did you have to mod the entire unit?

Here's a good overview from @AerialMediaPros regarding NDVI. AerialAgPros.com - Aerial Scouting, Mapping, and Precision Ag Drones

I don't have unusual noise per se, but to bring up the exposure it starts to get that gray look versus the right coloration. So lesson learned. Will have to expose higher instead.

DJI Forum Links - How to expose correctly if D-Log is fixed to ISO500 !!?? Dlog/RAW with X5S

Michael do you have any cheatsheet or table that you refer to for the settings? I'm used to the old DLOG model with the X5 on Inspire 1 where I would normally shoot at -0.3 to -0.7 versus the other way around. I wasn't aware of shooting over exposed in DLOG. I just shot a bunch of footage...

I came across this tread on DJI Forum page. Looks awesome. Working on doing this myself and having one made. I'm going to be using a RamCam Eagle 800TVL camera as my FPV camera and connecting it via the small 3 wire input on the Lightbridge. That way I can run my X5, X3, Z3, XT or Z30 as...

Found this today and thought I'd share. I hadn't seen anything like this in the past and helps me with identifying potential solution for dual camera like an XT and Z30 flying together to do inspections. DJI Matrice M600 Pro Dual Camera Video of it here -