Recent content by Flightworks

I've been flying pre-dawn when it is very cool, but the live thermal image is showing areas that are hot which are only ~6degrees C. There is a galaxy of hotspots which make it difficult to spot the wetland birds we are looking for. Also, areas of water are 'hot' white. I've attached a photo of...

Thank you! Will give it a try.

I'm flying the Matrice 4T. When the battery is low and triggers a RTH, the drone returns towards the flight base, which is great. I usually take control to land it, in some cases I need to if we are hand-catching. With other drones, switching to Sports mode and back gives me control, but with...

OK thanks. Good info again! Much appreciated.

Terrain Data is enabled under Flight Settings / Assist tab.

Further to this... I notice when I start up the M4T RC Plus controller, on the Preflight Check page of DJI Pilot 2, on the middle right side there is "Terrain Data" which is always saying it is "Converging altitude data..."... but never finishes this. Is this something to do with Terrain...

Thank you! We will have a deep dive into that and try to get the altitude correction working.

Thanks jaja6009. I'm about 100km, as the drone flys, from Auckland, New Zealand. I'm not using the RTK. What I don't understand is that the altitude in the flight logs is correct, but this is not used in the photo properties. Is the drone calculating the altitude correctly, then adding 40m for...

I'm using the M4T to search for rare bird nests in wetlands in New Zealand. We use software that auto-searches the thermal images for heat signatures of a certain parameter, and it maps these. The altitude from the photo properties is used to position the hot spots, but the altitude is...